626-333-7884

Model SEI-150
Wire Marking Machine Specifications

Wire Limits:
The SEI-150 will hot stamp wire with insulation of various materials from .040 to .250 in diameter.  Larger wire sizes available by special order.

Stamp Characters:
Each type wheel has 26 letters, 10 numbers, left arrow, right arrow, dash and a blank.  They can be furnished in both vertical or horizontal reading.  They are hardened and hard chrome plated for lasting quality. (Special characters are available at an extra charge).

Operator Interface Panel:
The SEI-150 is operated through an operator interface panel. The operator can set the spacing, dwell time and start the run.

Foil:
Foil can be furnished in various colors and will accommodate the standard insulation materials.  Foil feed is infinitely adjustable to the desired spacing.

Temperature:
The temperature of the type wheels is automatically controlled by the temp-control, heater and thermocouple.  Temperature may be infinitely adjusted from 0°F to 600°F.

Wire Fixtures:
Wire Guide fixtures can be furnished for various wire sizes.

Type Wheels:
Standard type wheels of your choice and quantity are provided with the machine and are normally centered on the mandrel.  More wheels may be used (at added cost).  A fast operating type selector bar is provided to adjust the wheels to the desired characters visually selected through a magnifier.

Stamp Pressure:
The stamping pressure may be adjusted from 0 to 60 PSIG by an air pressure regulator with a pressure gauge.  The air pressure controls the diaphragm-type actuator that requires no oil and withstands many actuations without failure.

Stamp Spacing:
This is adjustable from the operator interface panel.

Malfunction:
The machine will automatically stop and an indicator light will go on if; the stamp actuation is not completed (light from ready position goes off), shear actuation is not completed, type wheel bar is not in place or the foil runs out. When the problem has been solved, the machine may be restarted without losing the logic already programmed.

Emergency Stop:
The machine may be stopped with the emergency stop switch and restarted with the resume switch without affecting the programmed length, stamp spacing or number of pieces.

Dwell Time:
Dwell time is microprocessor controlled and may be set in .01 second increments.

Electrical Supply:
The SEI-150 requires 120 volt 60 HZ 10 AMP supply. We can provide for 230 volt 50 HZ at a nominal added cost.

Air Supply:
Supply air should be 100 to 120 PSIG with a water filter at the entrance to the machine. NO oiler should be used.

Note:
The Model SEI-150 Wire Marking Machine may be programmed to meet the marking requirements of military specification MIL-W-5088J.

Options:
Dereeler, table., high torque motor, large shear, and spark tester.

Upgrade Availability:
The SEI-150 can be upgraded to an SEI-250 and an SEI-450 for added shear capability.